With SUPER-WATER® polymer :

Examples of using SUPER-WATER® TECHNOLOGY.

HOLE PIERCING :

CHAMPFORGEUIL - France / VISTANEX® LM-MH - 180 mm thick
Photographs courtesy of Bourgogne Hydro

Partially cut than had to be broken by hand	Completely cut (*)
Intensifier : G+GENERATOR Cutting head : BOURGOGNE HYDRO Pressure : 3 400 bar Flow rate : 2 L/min Nozzle : 0,3 mm diameter Standoff : 5 mm

NILATRON :

NILATRON comparative cutting
With SUPER-WATER® polymer

Intensifier : Ingersoll-Rand Cutting head : CarlosaTM Pressure : 2 800 bar Flow rate : 1,4 L/min. Nozzle : 0,15 mm diameter Standoff : 4 mm

HOLE PIERCING :

SWITZERLAND - 1996
With SUPER-WATER® polymer

Intensifier : Ingersoll-Rand Cutting head : CarlosaTM Pressure : 3000 bar Abrasive : 120 mesh Nozzle : 0,8 mm diameter Standoff : 5 mm

ALUMINIUM Thickness 25 mm :

RONNEBY (Sweden) - 1997
With Intensifier Injection System (IISWTM) for
SUPER-WATER® - 0,3% : 200 / 250 g/min abrasive consumption
Plain water : 400 / 500 g/min abrasive consumption

Intensifier : Ingersoll-Rand - Type SL IV Cutting head : CarlosaTM Pressure : 3500 bar Flow rate : 1,80 L/min Nozzle : 0,25 mm diameter Standoff : 3 mm Cutting speed : 67,5 mm/min Abrasive : Quality GANEX - 80 mesh

FIRE BRICK - 23 cm x 11 cm x 6 cm :

Berkeley Chemical Research -1980 /85
On the left kerf with pure WATER only
On the right kerf with WATER + 0,3% SUPER-WATER®

Intensifier : Ingersoll-Rand - Type SL IV Cutting head : CarlosaTM Pressure : 620 bar Flow rate : 46 L/min Nozzle : 1,7 mm diameter Standoff : 23 mm Cutting speed : 30 cm/sec